2017-2019 Volkswagen Golf Alltrack Auto Start Stop Eliminator | Plug & Play
Description
2017-2019 Volkswagen Golf Alltrack Auto Start Stop Eliminator
The Volkswagen Golf Alltrack was sold in several equipment and transmission configurations, and available switch hardware can differ between vehicles. For an Alltrack that is equipped with the factory Start/Stop A/OFF control, drivers who prefer Start/Stop disabled may find themselves repeating the same button action after startup.
Automatic Start/Stop-Off Preference
The Recontrol-X Auto Start Stop Eliminator is designed for the 2017-2019 Volkswagen Golf Alltrack applications listed in the supplied fitment data, when the vehicle has the matching factory Start/Stop control and connector.
Once installed, the module is intended to place the Start/Stop function in the off state after startup, reducing the need to manually cancel it at the beginning of each drive.
This is a convenience accessory, not a performance device. It is not intended to change engine calibration, transmission programming, 4MOTION operation, drive modes, horsepower, or fuel economy, and it should not be used as a repair for an existing Start/Stop malfunction.
Compact 5.82-Inch Inline Harness
The supplied product images show a compact pass-through module measuring approximately 5.82 inches from connector to connector. The harness has two different black factory-style connector ends, along with a plastic trim-removal tool in the product imagery.
The hardware is designed around the vehicle's existing Start/Stop switch circuit. With a matching vehicle connector, the original plug is released and the Recontrol-X harness is inserted inline. The short module can then be routed behind the applicable center-console switch area before the trim is returned to place.
Because the product uses an inline connector arrangement, permanent cutting or splicing of the factory wiring is not required for the connection itself. Both locking tabs should be fully seated, and the harness should be routed so it is not pinched during reassembly.
Factory Control Remains Available
The purpose of the module is to automate the preferred off state while retaining the vehicle's original control.
The factory A/OFF button remains usable, allowing Start/Stop to be turned back on whenever the driver wants the factory system active for that trip.
The module is also reversible. Removing the eliminator and reconnecting the original vehicle plug returns the switch circuit to its previous connector arrangement.
Important Alltrack Compatibility Check
The supplied fitment data lists 2017, 2018 and 2019 Volkswagen Golf Alltrack, but it does not identify trim, engine, transmission, or market-specific equipment.
That distinction matters. Parts catalogs covering these Alltrack model years list separate multi-switch versions described as “with start stop” and “without start stop.” That is strong evidence that buyers should not assume every vehicle uses identical Start/Stop switch hardware.
Volkswagen of America's 2018 Golf Alltrack Order Guide also confirms that the model was sold in both six-speed manual and six-speed DSG automatic configurations.
Neither fact should be used to invent a transmission restriction in the Recontrol-X fitment table. The correct approach is simpler and safer: verify the actual A/OFF control and connector on the customer's vehicle.
What to Check Before Checkout
Confirm that your vehicle is a listed 2017-2019 Golf Alltrack, verify the presence of the factory Start/Stop A/OFF control, and compare the connector shape with the product images.
Do not add or assume a specific trim, transmission, or engine simply because another Alltrack uses a similar switch panel.
If the vehicle already has a Start/Stop warning or electrical fault, that issue should be diagnosed separately. For a correctly matched vehicle, the module offers a specific set of benefits: automatic Start/Stop-off preference after startup, retained factory-button control, a compact 5.82-inch harness, reversible inline installation, and no permanent modification of the original wiring for the connection.
Vehicle Fitment
Additional Information
| Brand | Recontrol-X |
Reviews
S&Q
Does this Auto Start Stop Eliminator fit my Golf Alltrack?
It is listed for 2017, 2018 and 2019 Volkswagen Golf Alltrack. Confirm that your vehicle has the factory Start/Stop A/OFF control and compare the switch connector with the product images before ordering.
Do all 2017-2019 Golf Alltrack vehicles use the same Start/Stop switch?
Do not assume they do. Parts catalogs for these model years list separate switch versions with Start/Stop and without Start/Stop, so physically checking the A/OFF control and connector is important before purchase.
Does transmission type determine compatibility?
The supplied fitment does not specify transmission. Volkswagen offered the 2018 Alltrack with both manual and DSG automatic transmissions, so do not use transmission alone to decide fitment. Verify the actual Start/Stop control and connector instead.
Can I still use the factory A/OFF button?
Yes. The module is designed to automate the preferred off state while keeping the original A/OFF control available, so you can reactivate Start/Stop when desired.
Can I remove the module later?
Yes. The approximately 5.82-inch inline harness uses connector-based installation. It can be removed and the original vehicle plug reconnected, returning the switch circuit to its previous arrangement without repairing cut wiring.